Dual-Gas Methane/Carbon Dioxide Sensor - Non Certified

Dual-Gas Premier Series of InfraRed (IR) Gas Sensors

Download Technical Data Sheet (pdf) - TDS0066

Dual-Gas Methane/Carbon Dioxide Sensor - Non Certified

Features

  1. Measurement range combinations up to 100% Vol. Methane (CH4) and 5% Vol. Carbon Dioxide (CO2)
  2. Contains all the necessary optics, electronics and firmware to provide THREE linearised, temperature-compensated measurements - Methane, Propane, Carbon Dioxide
  3. Simultaneous readings from the Hydrocarbon channel for High Resolution Methane and 0-2% Volume Propane
  4. Digital output format for direct interface to host circuitry
  5. Replaces individual infrared methane and carbon dioxide sensors with only half the power consumption
  6. Gives increased operating time for portable gas detectors
  7. Operating voltage 3 to 5 volts dc, nominal current = 80mA
  8. Wide operating temperature range of -20 to +50 deg. C
  9. Sensors can be factory configured to customer specifications
  10. User configurable via a configuration unit available from Dynament
  11. Internal 'Flash' memory enables firmware updates via the configuration unit
  12. Industry standard size - 20mm diameter x 16.6mm high
  13. Optional replaceable, self-adhesive micro porous 1 micron filter
Description

A combined High Resolution Methane (Hydrocarbon) and Carbon Dioxide sensor providing accurate measurement of gas levels using infrared gas sensing techniques. Various versions are available with combinations of ranges up to 100% volume Methane (CH4) and 5% volume Carbon Dioxide (CO2). They consume the power of a single infrared sensor and therefore provide prolonged battery life when used within portable gas detectors.

The Hydrocarbon channel provides simultaneous readings for both High Resolution Methane and Propane.

  1. Hydrocarbon Channel Resolution - 0.01% for range 0 to 10% Vol. and 0.1% for range 10% to 100% Vol. (CH4)
  2. Carbon Dioxide Channel Resolution - 0.01% Vol. (CO2)

The sensors are are intended for use either in non-certified gas detection equipment or in hazardous area certified equipment where the equipment manufacturer provides the necessary protection by means of a separately certified explosion protected housing.

They are contained in a stainless steel housing fitted with a single protective stainless steel mesh. This ensures a minimum response time to gas in applications where the sensor is to be fitted within a separately certified explosion protected housing protected by a sintered flame arrestor such as a sinter.

The construction of the non-certified types provide a small cost saving compared with the certified types.

A separately available Configuration Unit enables users to customise certain parameters within the Premier sensor in order to suit their particular requirements - see below.

Sensor Order Codes

The sensors are within the Dual-Gas Premier Series which commence with the code MSH-DP/HC/CO2/NC followed by additional codes to select positive or negative supply and filter option. Refer to end of the Technical Data Sheet for details.

(Note - infrared sensors cannot be used to detect Hydrogen)

More background information

Configuration Unit

The Premier Sensor Configuration unit enables users to customise certain parameters within the Premier sensor in order to suit their particular requirements. The unit is supplied complete with a PC software configuration package. Versions of the unit are available for either positive or negative supply sensors. Ordering details are as follows:

Positive version - Type P/CONFIG/POS
Negative version - Type P/CONFIG/NEG